Range Rover Evoque: Blower Motor LHD AWD/LHD FWD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES: Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. NOTE: The recirculation blend door must be closed in order for the removal of the recirculation blend door housing. Activate recirculation.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).
4. Refer to: Central Junction Box (CJB) (418-00 Module Communications Network, Removal and Installation).
5.
6.
7.
8. Torque: 10 Nm
9.
10.
11.
12.
13. Special Tool(s): 412-140
14.
15. CAUTION: Make sure that the special tool is correctly located.
NOTE: With assistance remove the component.
Installation
1.
2.
3. To install, reverse the removal procedure.
READ NEXT:
Blower Motor RHD AWD/RHD FWD, RHD
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essenti
Climate Control Assembly
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: LH illustration shown, RH is similar.
NOTE: The procedure must be carried out on both
sides.
Evaporator LHD
Removal
NOTES:
The removal of this component involves cutting an aperture in the evaporator
housing wall and cutting through the
high and low pressure A/C lines. A service repair kit is supplied to c
SEE MORE:
Rear seat head restraints
Adjust the head restraint so
that the
top of the head restraint is above the
centre line of the head. An incorrectly
adjusted head restraint increases the
risk of death or serious injury in the
event of a collision.
Do not drive or carry passengers with
the head restraint removed from an
Using tmc
Dynamic route guidance will calculate an
alternative route to avoid a traffic event when
the system receives an event warning.The
system calculates a new route for all sections.
However, if any way points are set, the system
calculates for the next way point.If the event on
route is serious (c
