Range Rover Evoque: Changing a road wheel

Changing a road wheel
1. Temporary spare wheel locking ring.
2. Temporary spare wheel retaining bolt.
3. Tool kit retaining bolt.
4. Jack.
5. Wheel brace.
After use, the tool kit
should be
returned to the under floor storage
area and correctly stowed.
The spare wheel is heavy and if
handled incorrectly may cause injury.
Use extreme caution when lifting or
manoeuvring the wheels.
Always secure the spare wheel, or the
removed wheel, in the correct position
using the retaining bolt.
Always remove the temporary spare wheel
before jacking the vehicle.
Note: Examine the jack occasionally, clean and
grease the moving parts, particularly the screw
thread, to prevent corrosion.
READ NEXT:
Remove the spare wheel prior
to
jacking the vehicle, to avoid
destabilising the vehicle when raised.
Do not use power tools to
loosen the
spare wheel. Doing so may damage the
mechanism.
1.
Always adhere to the
instructions
given on the temporary use spare
wheel warning label. Failure to
comply can be dangerous.
When a temporary use spare wheel is
fitted, drive with caution and r
Note: Wheel chocks are not supplied as part of
the tool kit.
Wheel chocks are a useful addition to a vehicle
tool kit. Note the following advice when using
wheel chocks.
Before raising the vehic
SEE MORE:
Draining
WARNING: Observe due care when draining, as the fluid can be very hot.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Make sure that the automatic transmission is in the PARK position
and the handbrake is fully applied.
2. Refer to
CAUTIONS:
Diagnosis by substitution from a donor vehicle is NOT acceptable.
Substitution of control modules does not
guarantee confirmation of a fault, and may also cause additional faults in the
vehicle being tested and/or the donor vehicle
When probing connectors to take measurements in the co
© 2011-2026 Copyright www.rrevoque.org
