Range Rover Evoque: Brake temperature
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control / Brake temperature
In extreme circumstances, the HDC system may cause brake temperatures to exceed their pre-set limits. An HDC warning will be displayed in the message centre. HDC will then fade out and become temporarily inactive.
Once the brakes have reached an acceptable temperature, the message will disappear (or the warning indicator will extinguish) and HDC will, if required, resume operation.
READ NEXT:
System fault
If a fault is detected in the HDC system, an HDC
warning will be displayed in the message
centre.
If the fault is detected while the system is
operating, HDC will then fade out.
If a fault is det
Automatic systems
Gradient Acceleration Control (GAC) and Hill
Start Assist are not active while HDC is
operating.
GAC will limit vehicle acceleration on steep
descents, allowing the driver to feel more in
control
SEE MORE:
Cylinder Block Components - 2.0L GTDi
Component Description
Front crankshaft oil seal
Front cover assembly
Knock sensor - cylinders 1 and 2
Gasket - thermostat housing
Thermostat
Cylinder block
Knock sensor - cylinders 3 and 4
Bolt (2 off)
Bolt (3 off)
Oil pump
Gasket - oil pump inlet
Oil pump filter and pick-up assembly
Engine Mount LH/RH
Engine Mount LH
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
S
© 2011-2025 Copyright www.rrevoque.org
