Range Rover Evoque: Hill descent control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control
- Hill descent control (HDC) controls
- Hdc operation
- Gradient release control (GRC)
- Brake temperature
- System fault
- Automatic systems
READ NEXT:
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd o
Hdc operation
With HDC engaged, standard descent speed
will not exceed 20km/h (12.4mph).
While the green warning lamp is continuously
illuminated, HDC target speed can be modified
using the cruise control steer
Gradient release control (GRC)
With HDC activated, if the vehicle is stopped on
a slope using the foot brake, GRC will become
active (except in Terrain Response Sand
program). It operates in all gears and in neutral
position.
SEE MORE:
Rear View Mirrors
Rear View Mirrors - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
DDM (driver door module)
Driver exterior mirror
Exterior mirror switches
Memory switches
Interior mirror (automatic dimming version shown)
PDM (passenger door
Front/Rear Door Latch
Front Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
Make sure the door window glass is in the fully closed position.
1. Refer to: Exterior Front Door Hand
© 2011-2025 Copyright www.rrevoque.org
