Range Rover Evoque: Brake temperature
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Hill descent control / Brake temperature
In extreme circumstances, the HDC system may cause brake temperatures to exceed their pre-set limits. An HDC warning will be displayed in the message centre. HDC will then fade out and become temporarily inactive.
Once the brakes have reached an acceptable temperature, the message will disappear (or the warning indicator will extinguish) and HDC will, if required, resume operation.
READ NEXT:
System fault
If a fault is detected in the HDC system, an HDC
warning will be displayed in the message
centre.
If the fault is detected while the system is
operating, HDC will then fade out.
If a fault is det
Automatic systems
Gradient Acceleration Control (GAC) and Hill
Start Assist are not active while HDC is
operating.
GAC will limit vehicle acceleration on steep
descents, allowing the driver to feel more in
control
SEE MORE:
Catalyst Monitor Sensor
Special Tool(s)
310-121
Wrench, H02S
Removal
WARNING: Observe due care when working near a hot exhaust system.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the batt
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
© 2011-2021 Copyright www.rrevoque.org