Range Rover Evoque: Cruise eco data

Diesel only

When enabled, a CO2 emission indicator is

When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEHICLE INFORMATION AND SETTINGS MENU.

READ NEXT:

 Stability control

 Dynamic stability control (DSC)

DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs. The vehicle is not designed for cornering at the sa

 Dsc warning lamp

The amber DSC warning lamp in the instrument panel illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC

SEE MORE:

 Side Air Bag Module

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation). 2. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery

 Opening and closing the bonnet

Opening and closing the bonnet Opening 1. Pull the bonnet release lever, located in the left-hand front footwell. 2. Lift the bonnet safety catch lever, located below the centre point of the bonnet, then raise the bonnet. Closing Do not drive with the bonnet retained by the safety catc

© 2011-2025 Copyright www.rrevoque.org