Range Rover Evoque: Timed climate remote control

The dedicated remote control has a range of approximately 100m (328ft). Press and hold the ON button for two seconds.

Note: Avoid touching the antenna when operating the ON or OFF button.

Timed climate remote control
Timed climate remote control

1. On button.
2. Off button.
3. LED (operation indicator).
4. Antenna.

Press and hold the ON button for approximately two seconds. The green LED will illuminate for 2 seconds to confirm that a program has been initiated. The LED flashes once every 2 seconds to indicate that the program is active.

The timed climate program will continue for 30 minutes and then switch off automatically to prevent the vehicle battery from discharging. It also turns off automatically if the engine is started.

The system may not operate, or will switch off automatically, if: - Fuel level is low.

- The vehicle’s battery charge is low.

- Engine coolant temperature is at or above its required temperature.

- The engine has not been started since the last programme cycle.

The remote control LED indicator signals other states and conditions for the timed climate as follows: - Illuminates red for 2 seconds when the OFF button is pressed, to indicate that the program has stopped.

- Flashes green or red for 2 seconds then stops when the ON or OFF buttons are pressed, to indicate that no action has been taken.

- Illuminates orange for 2 seconds before showing green or red, to indicate that the remote battery is low.

- Flashes orange for 5 seconds to indicate that no action has been taken and the remote battery should be replaced.

READ NEXT:

 Replacing remote control batteries

Replacing remote control batteries With the back of the remote control facing upwards, use a coin or similar implement to rotate the battery cover. Lift the cover off to reveal the battery compa

 Additional remote controls

A maximum of three controls can be programmed to each vehicle. Contact your Land Rover dealer to purchase additional units and have them programmed to your vehicle.

 Storage compartments

SEE MORE:

 Transfer Case Rear Seal

Special Tool(s) 100-012 Slide Hammer 205-871 Installer, Transfer Case Rear Seal 308-615 Remover, Seals 308-617 Depth Drill, Seal Remover Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is

 Engine oil check

Check the engine oil weekly. If any significant or sudden drop in oil level is noted, seek qualified assistance. Never allow the oil level to fall below the lower mark or notch on the dipstick. If the message ENGINE OIL PRESSURE LOW is displayed, stop the engine as soon as it is safe to do

© 2011-2025 Copyright www.rrevoque.org