Range Rover Evoque: Transfer Case Seal RH TD4 2.2L Diesel
Special Tool(s)
100-012
Slide Hammer
205-872
Installer, Transfer Case Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Halfshaft Seal RH - Vehicles With: M66 6-Speed Manual Transmission AWD (308-03 Manual Transmission/Transaxle, Removal and Installation).
3. Torque: 12 Nm
4. Torque: 12 Nm
5. Torque: 65 Nm
6.
- Special Tool(s): 308-617
7. CAUTIONS: Make sure that the area around the component is clean and free of foreign material.
Take extra care not to damage the mating faces.
- Special Tool(s): 308-615
- Special Tool(s): 100-012
Installation
1.
- Special Tool(s): 205-872
2. To install, reverse the removal procedure.
3. Check and top-up the transfer case fluid level.
Refer to: Transfer Case Fluid Level Check (308-07B Transfer Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual Transmission AWD, General Procedures).
Transfer Case - Vehicles With: AWF21 6-Speed Automatic Transmission/M66 6-Speed Manual Transmission AWD
Lubricants, Fluids, Sealers and Adhesives
Capacities
General Specification
Torque Specifications
READ NEXT:
Exhaust System
Exhaust System - GTDi 2.0L Petrol
Lubricants, Fluids, Sealers and Adhesives
* Apply to area around sensor threads prior to attempting to remove sensor
General Specification
Torque Specifications
**
Fuel System - General Information
Capacities
Fuel System Pressure Release GTDi
2.0L Petrol
Draining
1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety
Precautions (100-00 General Information, Description and
Operat
SEE MORE:
Auxiliary heater
Your vehicle may be fitted with an auxiliary
heater which is powered by fuel drawn from the
vehicle's tank. The heater operates only at low
ambient temperatures and is controlled by the
Timed climate control system or the heater
remote control.
When the heater is operating exhaust fumes
from
Timed climate remote control
The dedicated remote control has a range of
approximately 100m (328ft). Press and hold
the ON button for two seconds.
Note: Avoid touching the antenna when
operating the ON or OFF button.
Timed climate remote control
1. On button.
2. Off button.
3. LED (operation indicator).
4. Antenna.
