Range Rover Evoque: Bulb check
A warning lamp bulb check is initiated when the
ignition system is switched on and lasts for 3
seconds (except for the airbag warning lamp
which will remain on for 6 seconds). If any
warning lamp remains on after this period,
investigate the cause before driving.
Some warning lamps have associated
messages displayed on the message centre.
Note: Not all warning lamps are included in the
check (e.g. high beam headlamps and direction
indicators).
READ NEXT:
Critical warning message (red)
Illuminates when a critical warning
message is available in the
message centre.
Low oil pressure (red)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp remains on, flashes or
illuminates while driving, stop the v
Brake systems (red)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates while driving, suspect
low brake fluid level or a fault with the
Electronic Brake Distribution
SEE MORE:
Power Liftgate Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 4 Nm
3. Torque: 4 Nm
4.
Installation
1. To install, reverse the removal procedure.
Liftgate
Removal
CAUTION: The headliner must be lowered as a complete unit to gain access
to the
Special Tool(s)
205-857
Remover, Halfshaft
205-928
Remover, Half Shaft Inboard Joint
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft con
© 2011-2025 Copyright www.rrevoque.org
