Range Rover Evoque: Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine.

1. A valid Smart Key must be inside the vehicle.

2. Fully depress the clutch pedal.

3. Press and release the start button. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.

READ NEXT:

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

 Switching off the engine

Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied. 1. Select P for automatic transmission, or neutral for manual transmissions. Note: If any ot

 Switching off the engine with the vehicle moving

It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP

SEE MORE:

 Rear Wheel Bearing

Special Tool(s) 204-250 Wheel bearing install and removal tool 204-305 Remover, Wheel Bearing 204-726 Remover/Installer, Wheel Bearing JLR-204-806 Support Tool, Wheel Knuckle JLR-204-809 Installer, Rear Wheel Bearing JLR-204-810 Installer, Rear Wheel Bearing General Equipment Copper Hammer Hydrau

 Passenger Seat Cushion Heater Mat

Removal WARNINGS: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait

© 2011-2026 Copyright www.rrevoque.org