Range Rover Evoque: Switching off the engine with the vehicle moving

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Switching off the engine with the vehicle moving

off the It is not advisable to switch off the engine while the vehicle is moving.

However, should such a situation arise, then the following procedure applies.

- Press and hold the engine START/STOP button for 2 seconds, or; - Press the engine START/STOP button twice within 2 seconds.

In either case, the warning Engine Stop Button Pressed will be displayed in the message centre.

READ NEXT:

 Rolling re-start

If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated. Automatic transmission - select neutral (N) and then press the engine START/STOP button. When the en

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t

 Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on. When the engine has been stopped by the stop/start syst

SEE MORE:

 Fender Apron Panel Reinforcement

Removal NOTE: The fender apron panel reinforcement is manufactured from mild steel. 1. 2. For additional information relating to this repair procedure please see the following: For additional information, refer to: Health and Safety Precautions (100-00 General Information, Description and Operat

 Rear Side Member Section

Removal NOTES: The rear side member section is manufactured from RP260, with its inner reinforcement manufactured from DP600. The rear side member section is cut from the rear side member service panel, the section also includes the upper and lower side extensions. 1. In this procedure, to make s

© 2011-2026 Copyright www.rrevoque.org