Range Rover Evoque manuals

Range Rover Evoque: Fuel Tank and Lines - Component Location

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Fuel System / Fuel Tank and Lines - GTDi 2.0L Petrol / Fuel Tank and Lines - Component Location

Component Location

COMPONENT LOCATION - ROW

Range Rover Evoque. Fuel Tank and Lines - GTDi 2.0L Petrol

  1. Connection to purge valve
  2. Fuel Low Pressure (LP) sensor
  3. Fuel fired booster heater - fuel supply pipe connection (if fitted)
  4. LP fuel supply pipe
  5. Fuel fired booster heater - fuel supply pipe (if fitted)
  6. Fuel pump delivery module
  7. Fuel tank breather pipe
  8. Fuel filler cap
  9. Fuel tank filler pipe
  10. Fuel tank inlet hose and check valve
  11. Fuel tank
  12. Charcoal canister (reference only)
  13. Fuel Pump Driver Module (FPDM)
  14. Fuel tank vent breather pipe to charcoal canister
  15. Fuel vapor pipe from charcoal canister to purge valve
  16. Fuel vapor pipe to purge valve
  17. LP fuel supply connection to High Pressure (HP) pump

COMPONENT LOCATION - NAS

Range Rover Evoque. Fuel Tank and Lines - GTDi 2.0L Petrol

  1. Connection to purge valve
  2. Fuel Low Pressure (LP) sensor
  3. LP fuel supply pipe
  4. Fuel pump delivery module
  5. Fuel tank breather pipe
  6. Fuel filler cap
  7. Fuel tank filler pipe
  8. Fuel tank inlet hose and check valve
  9. Fuel tank
  10. DMTL pump
  11. Charcoal canister (reference only)
  12. Fuel Pump Driver Module (FPDM)
  13. Fuel tank vent breather pipe to charcoal canister
  14. Fuel vapor pipe from charcoal canister to purge valve
  15. Fuel vapor pipe to purge valve
  16. LP fuel supply connection to High Pressure (HP) pump

Overview

OVERVIEW

The fuel system is divided into 2 sub systems:

The low pressure system features the following components:

The low pressure system pressure is 4.5 bar (65.3 lbf/in

READ NEXT:

 Fuel Tank and Lines - System Operation and Component Description

Control Diagram NOTE: A = Hardwired Battery Battery Junction Box (BJB) Fuel Pump Driver Module (FPDM) Fuel pump delivery module Engine Control Module (ECM) Central Junction Box (CJB) System O

 Fuel Filter

Special Tool(s) 310-123 Locking Ring, Fuel Tank Removal WARNINGS: Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system. Avoid flame

 Fuel Tank

Special Tool(s) 310-123 Locking Ring, Fuel Tank Removal WARNINGS: Fuel may still be present in the fuel tank after draining. Avoid flames, sparks or lighted substances. CAUTIONS: Extreme cleanliness

SEE MORE:

 Component Description

LEFT STEERING COLUMN MULTIFUNCTION SWITCH Off position Side lamps position Headlamps position AUTO - Automatic headlamps position (if fitted) Front fog lamps switch Rear fog lamps switch High beam Right turn signal indicator Left turn signal indicator High beam position High beam flash

 Catalyst Monitor Sensor

Special Tool(s) 310-121 Wrench, H02S Removal WARNING: Observe due care when working near a hot exhaust system. NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Disconnect the batt

© 2011-2026 Copyright www.rrevoque.org