Range Rover Evoque: Fuel Tank and Lines - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Fuel System / Fuel Tank and Lines - GTDi 2.0L Petrol
- Fuel Tank and Lines - Component Location
- Fuel Tank and Lines - System Operation and Component Description
- Fuel Filter
- Fuel Tank
- Fuel Tank and Lines - Diagnosis and Testing
READ NEXT:
Fuel Tank and Lines - Component
Location
Component
Location
COMPONENT LOCATION - ROW
Connection to purge valve
Fuel Low Pressure (LP) sensor
Fuel fired booster heater - fuel supply pipe connection (if fitted)
LP fuel supply pipe
Fuel
Fuel Tank and Lines - System
Operation and Component Description
Control Diagram
NOTE: A = Hardwired
Battery
Battery Junction Box (BJB)
Fuel Pump Driver Module (FPDM)
Fuel pump delivery module
Engine Control Module (ECM)
Central Junction Box (CJB)
System O
Fuel Filter
Special Tool(s)
310-123
Locking Ring, Fuel Tank
Removal
WARNINGS:
Wait for a minimum of 1 minute after the engine has stopped before
carrying out any repair to the fuel injection
system.
Avoid flame
SEE MORE:
Rear Bumper Mounting
Removal
NOTE: The rear bumper mounting is manufactured from mild steel.
1. In this procedure, to make sure the vehicle is correctly
aligned, it must be placed on an approved alignment
jig.
2. The rear bumper mounting is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
3.
Back Panel
Removal
NOTES:
The back panel is manufactured from mild steel, it includes the bumper
retaining bracket.
It is necessary to remove a section of both rear lamp mounting panels to enable
removal and installation of the back panel.
1. The back panel is replaced in conjunction with:
Rear bumper cov
© 2011-2026 Copyright www.rrevoque.org - 0.0042
