Range Rover Evoque manuals

Range Rover Evoque: Automatic transmission

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Gearbox / Automatic transmission

The rotary drive selector rotates in either direction. At engine start up, the selector elevates out of its parked position.

1. To select D (Drive) or R (Reverse) gear,

1. To select D (Drive) or R (Reverse) gear, apply the foot brake then rotate the drive selector. The related LED by the selector will illuminate.

Note: If pressure is applied to the selector before the foot brake is applied, the selected gear may not be available. In this situation, remove pressure from the selector, ensure that the foot brake is applied and select the required gear as described.

2. To select S (Sport) mode from D, press the drive selector down and rotate to S. The related LED by the selector will illuminate.

3. CommandShiftTM gear selector paddles (left paddle for downshifts, right paddle for upshifts).

4. Pull a paddle briefly to change gear.

To exit CommandShiftTM mode and return to Sport mode, pull and hold the upshift (+) paddle for approximately one second.To return to Drive mode, move the selector back to the D position.

5. The selected gear will be displayed in the message centre.

remain Do not allow the vehicle to remain stationary for a sustained period, with a gear selected and the engine running.
This vehicle must not be push or tow started.

READ NEXT:

 Park

Use when the vehicle is parked. The transmission will be locked. Park (P) or Neutral (N) should be engaged and the parking brake applied when the vehicle is stationary. Always select P and sw

 Reverse gear

Never select Reverse (R) when the vehicle is in forward motion. Before selecting reverse gear, ensure the vehicle is stationary and the brakes are applied. Rotate to R.

 Neutral

Disconnects drive to the wheels. Use the parking brake while N is selected. Do not use for vehicle recovery purposes.

SEE MORE:

 Front Side Member Section

Removal NOTES: The front side member is manufactured from RP260 and DP600. The front side member section is cut from the front side member and is manufactured from RP260. This procedure is written for the LH front side member section replacement, the LH and RH front side member sections differ i

 Seats - System Operation and Component Description

Control Diagram NOTE: A = Hardwired; N = Medium speed CAN (controller area network) bus; O = LIN (local interconnect network) bus CONTROL DIAGRAM - FRONT POWER OPERATED NON-MEMORY SEATS Driver seat forward-rearward motor Driver seat recline motor Driver seat height motor Driver lumbar pump D

© 2011-2025 Copyright www.rrevoque.org