Range Rover Evoque: Gearbox
- Automatic transmission
- Park
- Reverse gear
- Neutral
- Drive
- Sport mode
- Commandshift™
- Kick-down
- Drive selector
- Drive selector fails to elevate
- Transmission fault
- Manual transmission
- Gear shift indicator
READ NEXT:
Automatic transmission
The rotary drive selector rotates in either
direction. At engine start up, the selector
elevates out of its parked position.
1. To select D (Drive) or R (Reverse) gear,
apply the foot brake then
Park
Use when the vehicle is parked. The
transmission will be locked.
Park (P) or Neutral (N)
should be
engaged and the parking brake
applied when the vehicle is
stationary.
Always select P and sw
Reverse gear
Never select Reverse (R) when
the
vehicle is in forward motion.
Before selecting reverse gear, ensure the
vehicle is stationary and the brakes are applied.
Rotate to R.
SEE MORE:
Transmission Control Module (TCM) TD4 2.2L
Diesel
Removal
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Air Cleaner (303-12, Removal and Installation).
3.
4.
5. CAUTION: Discard the component.
6.
7.
Installation
1. Torque: 25 Nm
2.
3. Torque:
M10 47 Nm
Transfer Case
Connecting Sleeve Seals TD4 2.2L Diesel, Vehicles With: AWF21 6-Speed
Automatic Transmission
Special Tool(s)
100-012
Slide Hammer
307-594
Installer, Seal
308-005
Remover, Axle oil seal
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
© 2011-2026 Copyright www.rrevoque.org
