Range Rover Evoque: Sport mode

The transmission will stay in the lower gears for longer, improving mid-range performance.

To deselect Sport mode, move the selector back to D.

READ NEXT:

 Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the tra

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

SEE MORE:

 Front Stabilizer Bar Bushing

Removal NOTES: Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the front wheels

 Rear Wheel Bearing

Special Tool(s) 204-250 Wheel bearing install and removal tool 204-305 Remover, Wheel Bearing 204-726 Remover/Installer, Wheel Bearing JLR-204-806 Support Tool, Wheel Knuckle JLR-204-809 Installer, Rear Wheel Bearing JLR-204-810 Installer, Rear Wheel Bearing General Equipment Copper Hammer Hydrau

© 2011-2023 Copyright www.rrevoque.org