Range Rover Evoque: Drive selector
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Gearbox / Drive selector
P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console.
If the engine is switched off with N selected, the system will wait for 10 minutes before selecting P. This time delay allows the vehicle enough time to be conveyed through a car wash. Do not use for vehicle recovery purposes.
If your vehicles requires recovery by towing, the recovery must be undertaken by qualified personnel. See 216, RECOVERY.
READ NEXT:
Drive selector fails to elevate
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
Manual transmission
Manual transmission
Selection of reverse gear is
prevented
when the vehicle is travelling in excess
of 24km/h (15mph). Never attempt to
engage reverse gear while the vehicle is
in forward mo
SEE MORE:
Manual Transmission FWD
Component
Location
COMPONENT LOCATION
Manual transmission
Selector lever assembly
Overview
OVERVIEW
The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford
in Cologne, Germany. The transmission
is a highly compact 4 shaft design, incorporating the front final drive gear.
Manual Transmission/Transaxle External Controls
Torque Specifications
External Controls -
Component Location
COMPONENT LOCATION
Shift cables
Gear knob
Selector lever assembly
Selector lever mounting plate
External Controls -
Overview
OVERVIEW
The manual transmission external controls comprise a selector lever and two
shift cables. The se
© 2011-2026 Copyright www.rrevoque.org - 0.0042
