Range Rover Evoque: Park

Use when the vehicle is parked. The transmission will be locked.

should be Park (P) or Neutral (N) should be engaged and the parking brake applied when the vehicle is stationary.
Always select P and switch off the ignition before leaving the vehicle.

the vehicle Never select Park (P) when the vehicle is in motion.

READ NEXT:

 Reverse gear

Never select Reverse (R) when the vehicle is in forward motion. Before selecting reverse gear, ensure the vehicle is stationary and the brakes are applied. Rotate to R.

 Neutral

Disconnects drive to the wheels. Use the parking brake while N is selected. Do not use for vehicle recovery purposes.

 Drive

Never select a forward gear when the vehicle is in rearward motion. Gear changing is fully automatic. Shift points are determined by accelerator pedal position and current road speed.

SEE MORE:

 Transmission Control Module (TCM), Gear Shift Module (GSM)

TRANSMISSION CONTROL MODULE (TCM) TCM Neutral 'N' position Park 'P' position Position sensor/manual shaft Electrical connector The TCM is located on the top of the transmission casing and is connected on the high speed CAN (controller area network) bus to send and receive information to and

 Crankshaft Position (CKP) Sensor

Special Tool(s) 303-1390A CKP Sensor Alignment Tool JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Wheel and Tire

© 2011-2025 Copyright www.rrevoque.org