Range Rover Evoque: Opening and closing the bonnet

Opening and closing the bonnet
Opening
1. Pull the bonnet release lever, located in the
left-hand front footwell.
2. Lift the bonnet safety catch lever, located
below the centre point of the bonnet, then
raise the bonnet.
Closing
Do not drive with the bonnet
retained
by the safety catch alone.
3. Lower the bonnet until the safety catch
engages. Using both hands, press the
bonnet down until the catches click. Check
that both catches are engaged by trying to
lift the front edge of the bonnet.
READ NEXT:
Fluids used in motor vehicles are poisonous
and should not be consumed or brought into
contact with open wounds.
For your own safety, always read and obey all
instructions printed on labels and co
Prolonged contact with engine oil may cause
serious skin disorders, including dermatitis
and cancer of the skin. Always wash
thoroughly after contact.
It is illegal to pollute drains,
water
co
Engine compartment overview
2.0L petrol engine
1. Brake/clutch fluid reservoir caps (beneath
covers):
A. Left-hand drive vehicles.
B. Right-hand drive vehicles.
2. Engine oil filler cap.
5. O
SEE MORE:
Special Tool(s)
100-012
Slide Hammer
303-1300
Remover, Crankshaft Seal
303-538
Remover/Installer, Crankshaft Oil Seal
307-594
Installer, Seal
307-595
Installer, Intermediate Shaft Seal
308-615
Remover, Seals
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information
CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable.
Substitution of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOTES:
If the control module or a component is susp
© 2011-2026 Copyright www.rrevoque.org
