Range Rover Evoque: Steering Column Switches
Torque Specifications
Steering Column Multifunction Switch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Removal of the windshield wiper switch assembly is identical to this procedure.
1.
2.
3.
4.
5.
Installation
1. To install, reverse the removal procedure.
Ignition Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: LH illustration shown, RH is similar.
NOTE: The step must be carried out on both sides.
4.
5. Torque: 6 Nm
6.
7. Torque: 1.5 Nm
8.
Installation
1. To install, reverse the removal procedure.
Steering Column Lock Module
Removal
NOTES:
Removal steps in this procedure may contain installation details.
The steering column lock module is retained with 2 patch locked, tamper proof bolts.
1. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
2. Using a suitable stud extraction tool, remove the tamper proof bolts.
Installation
1. CAUTION: Tighten the new tamper proof bolts until the hexagon shears. To install, reverse the removal procedure.
2. Using the Land Rover approved diagnostic system, calibrate a new module.
3. If a new component is installed, the soft lock stop reset routine should be completed on the power steering system, using the approved diagnostic tool.
READ NEXT:
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge o
SEE MORE:
Vehicle Recovery
Towing Points
CAUTION: The
single towing points at the front and rear of the vehicle are designed for
vehicle recovery purposes
only and must NOT be used to tow a trailer or caravan.
The front towing eye is accessible after releasing the 2 toggle fasteners
securing the towing eye access panel
Headlamp washers
The optional headlamp power wash operates
automatically with the windscreen wash and
will operate only If the headlamps are switched
on and there is sufficient washer fluid in the
reservoir.
Headlamp wash operates every fourth
operation of the screen washers, provided the
headlamps are still
