Range Rover Evoque: Timing Chain
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is always correct.
1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
3. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
4.
5.
6.
7.
8. CAUTIONS:
Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.
Note the fitted position of the component prior to removal. Do not disassemble further if removed for access only
9.
Installation
1. CAUTION: Install a new friction washer.
2. CAUTIONS:
Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning.
Make sure that these components are installed to the noted removal position.
Only tighten the bolts finger-tight at this stage.
3.
4. Torque: 10 Nm
5. Torque: 10 Nm
6. CAUTION: Use an open-ended wrench to hold the camshafts by the hexagon to prevent the camshafts from turning. Torque: 72 Nm
7. Refer to: Timing Cover (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
8. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
READ NEXT:
Timing Cover
Special Tool(s)
303-021
Engine support bracket
JLR-303-1591
Lifting Bracket, Engine - Rear
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustratio
Valve Cover
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Engine - Removal and Installation
Removal
Special Tool(s)
205-857
Remover, Halfshaft
1. Refer to: Battery Tray (414-01 Battery, Mounting and Cables,
Removal and Installation).
2. Refer to: Air Conditioning (A/C) System Recovery, Evacu
SEE MORE:
Locking wheel nuts
Locking wheel nuts can be removed only by
using the special adapter provided in the tool
kit.
Note: When the vehicle is first supplied, the
adapter may be stored in the glove
compartment. It should be removed and stored
in the tool kit as soon as possible.
Note: A code number is stamped onto
Headphones
The volume control for each set of headphones
is adjusted on the headphones.
Press the channel selector button to cycle
through available channels. Select the channel
appropriate for the required screen.
Note: These headphones are not intended for
use by the driver or outside the vehicle.
Not
