Range Rover Evoque: Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. WARNING: Make sure that a new nut is installed. Torque: 60 Nm
4.
5. WARNING: Make sure that a new bolt is installed. Torque: 200 Nm
6. WARNING: Make sure that a new bolt is installed.
Torque:
Stage 1: 48 Nm
Stage 2: 180
READ NEXT:
Front Stabilizer Bar AWD
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
Only use clean water as a lubricant for the bushing, if required.
Removal steps in this pro
Front Stabilizer Bar Bushing
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. WARNING: Make sure
Wheel Knuckle
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
sus
SEE MORE:
Engine Cover GTDi 2.0L Petrol, Engine Cover TD4 2.2L Diesel
Engine Cover GTDi 2.0L Petrol
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Do not disassemble further if the
component is removed for access only.
Installation
1. To install, reverse the removal procedure.
Engine Cover TD4 2.2L Diesel
Removal
1. Torqu
Using the repair kit
Avoid skin contact with the
sealant
which contains natural rubber latex.
Do not unscrew the sealant bottle from
the receiver until it is empty, as
sealant will leak out.
If the tyre inflation pressure does not
reach 1.8 bar (26 lb/in²) within seven
minutes, the tyre may have suffered
© 2011-2025 Copyright www.rrevoque.org
