Range Rover Evoque: Front Suspension

READ NEXT:

 Front Suspension - Component Location, System Operation and Component Description

Component Location RH (right-hand) spring and damper assembly Stabilizer bar link Stabilizer bar LH (left-hand) spring and damper assembly Wheel knuckle Hub and bearing assembly Lower control

 Front Wheel Bearing

Special Tool(s) 204-305 Remover, Wheel Bearing 204-726 Remover/Installer, Wheel Bearing 204-727A Installer, Wheel Bearing JLR-204-806 Support Tool, Wheel Knuckle JLR-204-807 Installer, Front Wheel B

 Lower Arm

Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. NOTES: RH illustration shown, LH is similar. Removal steps in this procedure may contain installat

SEE MORE:

 Before programming

When programming a device that may require you to press and re-press the hand-held transmitter (cycle), unplug the device during the cycling process to prevent possible motor failure. For best results, fit a new battery to the hand-held transmitter of the garage door opener (or other devic

 Mislock

When locking the vehicle with the Smart Key, if one or more of the doors, the bonnet or the tailgate is not fully closed, or the ignition is ON, the vehicle will NOT lock and there will be an audible mislock error warning. The hazard warning lamps will NOT flash and the door mirrors (if enable

© 2011-2026 Copyright www.rrevoque.org