Range Rover Evoque: Oil check preparation

Prior to checking the oil level ensure that: - The vehicle is on level ground.

- The engine oil is cold.

Note: If it is necessary to check the oil level when the engine is hot, switch off the engine and let the vehicle stand for 5 minutes to allow the oil to drain back into the sump. Do not start the engine.

The oil level can then be checked as follows: 1. Withdraw the dipstick and wipe the blade clean with a lint free cloth.

2. Fully re-insert the dipstick and withdraw again to check the oil level.

As a general guide, if the oil level on the dipstick: - Is nearer to the upper mark or notch than the lower, do not add oil.

- Is nearer to the lower mark or notch than the upper, add 0.5 litre (1 pint) of oil.

- Is below the lower mark or notch, add for the diesel engine, 1.5 litre (2.6 pints) of oil and for the petrol engine, 0.8 litre (1.4 pints) of oil. Re-check the level after a further 5 minutes.

READ NEXT:

 Topping up the engine oil

Your vehicle warranty may be invalidated if damage is caused by using oil that does not meet the required specification. Failure to use an oil that meets the required specification could cause

 Engine oil specification

It is important that the correct oil specification is used. Vehicles fitted with a diesel particulate filter (DPF) must use the specified oils otherwise significant engine damage will occur. Speci

 Coolant level check

Running the engine without coolant will cause serious engine damage. The coolant level in the expansion tank should be checked at least weekly (more frequently in high mileage or arduous operat

SEE MORE:

 Transmission Description - Component Location

Component Location COMPONENT LOCATION Auxiliary battery module Transmission Control Switch (TCS) Upshift (+) paddle switch Downshift (-) paddle switch Transmission and Gear Shift Module (GSM) breathers Automatic transmission Gear Shift Module (GSM) Transmission Control Module (TCM) Transm

 Exhaust System

Exhaust System - GTDi 2.0L Petrol Lubricants, Fluids, Sealers and Adhesives * Apply to area around sensor threads prior to attempting to remove sensor General Specification Torque Specifications ** It is not appropriate to either fit or remove these fixings using air tools due to a risk of cold

© 2011-2025 Copyright www.rrevoque.org