Range Rover Evoque: Seat belt safety
Care should be taken to avoid
contamination of the webbing with
polishes, oils and chemicals, and
particularly battery acid. Cleaning
may safely be carried out using mild
soap and water.
The belt should be replaced if
webbing becomes frayed,
contaminated or damaged.
It is essential to replace the entire
assembly after it has been worn in a
severe impact even if damage to the
assembly is not obvious.
If any damage, wear, cuts, defects, or
impaired operation are noted with the
seat belts, the vehicle should be taken
to a Land Rover Dealer/Authorised
Repairer for immediate attention. Do
not use the vehicle if the seat belts
cannot be operated correctly.
Do not carry hard, fragile, or sharp
items between your person and the
seat belt.
Seat belts should be worn by all
vehicle occupants, for every journey
no matter how short.
Never wear just the lap belt or just the
shoulder belt of a lap/shoulder
diagonal seat belt. Both of these
actions are extremely dangerous and
may increase your risk of injury.
When using seat belts to restrain
items other than occupants, take care
to ensure that the belts are not
damaged, or exposed to sharp edges.
READ NEXT:
Seat belt checks
Note: If the vehicle is parked on an incline, the
seat belt mechanism may lock. This is not a
fault and the belt should be gently eased out
from the upper anchorage.
The seat belts should be inspe
Seat belt reminder
Seat belt reminder
If a front seat belt is not fastened
when the vehicle is in motion, a
chime will be heard and the seat
belt warning lamp will illuminate.
Note: Objects on the front passenger
Beltminder
A front and rear seat Beltminder system warns
the driver when the seat belt of an occupied
seat is not fastened or is unfastened during a
journey.
Beltminder
A graphic accompanied by a text mes
SEE MORE:
Tyre care
Do not drive the vehicle if a
tyre is
damaged, excessively worn, or
incorrectly inflated.
Avoid contaminating the tyres with
vehicle fluids as they may cause
damage to the tyre.
Avoid spinning the wheels. The forces
released can damage the structure of
the tyre and cause it to fail.
If w
Exterior Trim and Ornamentation
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre part of the clip is fully
removed from the outer part of the clip. It is not
possible to prevent
