Range Rover Evoque: Steering Column Switches
Torque Specifications
Steering Column Multifunction Switch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Removal of the windshield wiper switch assembly is identical to this procedure.
1.
2.
3.
4.
5.
Installation
1. To install, reverse the removal procedure.
Ignition Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: LH illustration shown, RH is similar.
NOTE: The step must be carried out on both sides.
4.
5. Torque: 6 Nm
6.
7. Torque: 1.5 Nm
8.
Installation
1. To install, reverse the removal procedure.
Steering Column Lock Module
Removal
NOTES:
Removal steps in this procedure may contain installation details.
The steering column lock module is retained with 2 patch locked, tamper proof bolts.
1. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
2. Using a suitable stud extraction tool, remove the tamper proof bolts.
Installation
1. CAUTION: Tighten the new tamper proof bolts until the hexagon shears. To install, reverse the removal procedure.
2. Using the Land Rover approved diagnostic system, calibrate a new module.
3. If a new component is installed, the soft lock stop reset routine should be completed on the power steering system, using the approved diagnostic tool.
READ NEXT:
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge o
SEE MORE:
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
205-754A
Splitter, Ball Joints
205-857
Remover, Halfshaft
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTE: Some variation in the illustratio
Connecting a device
Connecting a device
1. USB/iPod sockets.
2. 3.5 mm AUX socket.
3. Rear media USB/iPod socket.
4. Rear media AV sockets.
Connect the device into the appropriate socket.
Note: Use the cable supplied with your media
device to connect to the USB socket.
When an iPod is connected, playback will
