Range Rover Evoque: Changing a road wheel

Changing a road wheel
1. Temporary spare wheel locking ring.
2. Temporary spare wheel retaining bolt.
3. Tool kit retaining bolt.
4. Jack.
5. Wheel brace.
After use, the tool kit
should be
returned to the under floor storage
area and correctly stowed.
The spare wheel is heavy and if
handled incorrectly may cause injury.
Use extreme caution when lifting or
manoeuvring the wheels.
Always secure the spare wheel, or the
removed wheel, in the correct position
using the retaining bolt.
Always remove the temporary spare wheel
before jacking the vehicle.
Note: Examine the jack occasionally, clean and
grease the moving parts, particularly the screw
thread, to prevent corrosion.
READ NEXT:
Remove the spare wheel prior
to
jacking the vehicle, to avoid
destabilising the vehicle when raised.
Do not use power tools to
loosen the
spare wheel. Doing so may damage the
mechanism.
1.
Always adhere to the
instructions
given on the temporary use spare
wheel warning label. Failure to
comply can be dangerous.
When a temporary use spare wheel is
fitted, drive with caution and r
Note: Wheel chocks are not supplied as part of
the tool kit.
Wheel chocks are a useful addition to a vehicle
tool kit. Note the following advice when using
wheel chocks.
Before raising the vehic
SEE MORE:
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variable
ratio, rack and pinion steering and speed sensitive power assistance. Power
assistance is from a
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove the four grille fixings.
4. Remove the two retaining bolts.
5. At the rear of the headlamp unit, p
© 2011-2025 Copyright www.rrevoque.org
