Range Rover Evoque: Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener or entry gate,
ensure the area is clear. This will
prevent potential harm or damage as
the gate or garage door will activate
during the programme.
This device may suffer from
interference if operated in the vicinity of
a mobile or fixed station transmitter.
This interference is likely to affect the
hand-held transmitter as well as the
in-car transceiver.
This feature is also known as the HomeLink® Universal Transceiver. See 55, INFORMATION AND ASSISTANCE.
The HomeLink transceiver is located in the rear view mirror. It can be programmed to transmit the radio frequencies of up to three different transmitters, which can be used to operate garage doors, entry gates, home lighting, security systems or other radio frequency operated devices.
Although this section mainly describes the procedures for a garage door opener, it equally applies to the previously mentioned applications.
READ NEXT:
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Rolling code device equipment programming
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
SEE MORE:
Front Seat Cushion Cover Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on how to correctly install
and care for the seat cover.
2.
3.
4. If required, follow the steps below
Dual view control menu
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Select to view a list of all available video
sources. Touch the relevant soft key to
select an alter
