Range Rover Evoque: Keyless start backup
If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start the engine.
The keyless start backup can only be used when the message Smart Key Not Found Refer to Handbook is displayed in the message centre.
Position the Smart Key against the underside of the steering column cover with the buttons facing downwards.
With the brake (Auto) or clutch (Man) pedal depressed, press and release the START/STOP button to start the engine.
When the engine starts, you no longer need to hold the Smart Key beneath the steering column.
Note: If the Smart Key is not recognised or the engine still fails to start, consult your Dealer/ Authorised Repairer.
Note: If the message Smart Key Not Detected is displayed, ensure that the key is being held in the correct position and try again.
READ NEXT:
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
Conditions preventing automatic engine stop
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not re
Conditions causing automatic engine restart
The engine will automatically start if:<>
- climate control system demand increases
- the vehicle’s speed reaches approximately 4km/h (2.5mph)
- HDC or a Terrain Response special program ar
SEE MORE:
Seat belt checks
Note: If the vehicle is parked on an incline, the
seat belt mechanism may lock. This is not a
fault and the belt should be gently eased out
from the upper anchorage.
The seat belts should be inspected regularly to
check for fraying, cuts, wear to the webbing
and the condition and security of t
Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the
edges of the component.
2.
3. NOTE: Do not disassemble further if the
component is removed for access only.
4. CAUTION: Take extra care not to damage the
wiring harnesses.
