Range Rover Evoque: Garage door opener
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener
- Garage door transceiver
- Before programming
- Programming
- Rolling code device equipment programming
- Reprogramming a single garage door opener button
- To erase all programming
- Entry gate programming
- Information and assistance
READ NEXT:
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
SEE MORE:
Door lock and release levers
Door lock and release levers
1. Press a locking lever to lock a door. Pull the
lever back to unlock. Operating either front
door locking levers will lock or unlock all
doors.
2. Pull a release lever to open a front door.
To unlock and open a rear door, first
operate the lock lever, then pul
Drive Pinion Flange Vehicles With: AWF21
6-Speed Automatic Transmission
Special Tool(s)
205-053
Retainer, Drive Flange
Removal
All vehicles
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
Vehicles with diesel engine
2. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L
Diesel, Removal and Installation).
Vehicles wit
© 2011-2025 Copyright www.rrevoque.org
