Range Rover Evoque: If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult your Dealer/Authorised Repairer.
Diesel engines:
If the engine persistently fails to start, make
sure the transmission is in P or N (neutral for
manual transmission vehicles) then press the
START/STOP button (with the brake pedal
applied). Keep the START/STOP button and the
brake pedal pressed until the engine starts,
then release.
If the engine still fails to crank, or fails to start
consult your Dealer/Authorised Repairer.
READ NEXT:
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
SEE MORE:
Removal
NOTES:
The rear lamp mounting panel is manufactured from mild steel.
The section of the rear lamp mounting panel described within this procedure is
for the access for installation of the
inner back panel assembly.
The upper NVH component must be replaced when a complete panel is installed
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Glove Compartment (501-12 Instrument Panel and Console,
Removal and Installation).
3.
© 2011-2025 Copyright www.rrevoque.org
