Range Rover Evoque: Replacement tyres

Do not fit tubed tyres. Do not fit cross ply tyres.
Do not fit tubed tyres.
Do not rotate tyres around the vehicle.
If the use of tyres not recommended by Land Rover is unavoidable, ensure that you read and fully comply with the tyre manufacturer’s instructions.

Ideally, tyres should be replaced in sets of 4. If this is not possible, replace the tyres in pairs (both front or both rear). When tyres are replaced, the wheels should always be re-balanced and alignment checked.

READ NEXT:

 Tyre pressure compensation for low ambient temperature changes

A colder ambient local temperature will reduce pressure within the tyre. An effect is to decrease sidewall height and to increase tyre shoulder wear with the potential for tyre failure. Vehicle dy

 Tyre pressure compensation - high ambient temperatures

 Flat spots due to long term parking

In order to minimise flat spotting, the tyre pressures can be increased to the maximum as stated on the tyre sidewall, for the period when the vehicle is stationary. Tyres must be returned to the

SEE MORE:

  Anti-Lock Control

Torque Specifications Anti-Lock Brake System (ABS) Module Removal CAUTIONS: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. Make sure that all openings are sealed. Use new blanking caps. NOTES: Removal steps in this procedure may contai

  Anti-Lock Control - Traction Control AWD

Component Location NOTE: RHD (right-hand drive) installations shown; LHD (left-hand drive) installations similar. COMPONENT LOCATION - SHEET 1 OF 2 RH (right-hand) front wheel speed sensor RH rear wheel speed sensor LH (left-hand) rear wheel speed sensor LH front wheel speed sensor Integrate

© 2011-2026 Copyright www.rrevoque.org - 0.004