Range Rover Evoque: Garage door opener
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener
- Garage door transceiver
- Before programming
- Programming
- Rolling code device equipment programming
- Reprogramming a single garage door opener button
- To erase all programming
- Entry gate programming
- Information and assistance
READ NEXT:
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
SEE MORE:
Starting a disabled vehicle using booster cables
Rotating parts of the engine
can cause
serious injury. Take extreme care
when working near rotating parts of
the engine.
Before attempting to start the disabled
vehicle, make sure that the parking
brake is applied, or suitably chock the
wheels. Make sure that Park is
selected or the manua
adaptive front lighting system (AFS)
With the headlamps on, AFS will adjust the
beams when cornering to provide improved
illumination in the direction of travel.
When a direction indicator is activated at
speeds up to 40km/h (25mph), an additional
lamp set at 45o in the direction of turn is
illuminated. This broadens the beam of
© 2011-2025 Copyright www.rrevoque.org
