Range Rover Evoque manuals

Range Rover Evoque: Engine starting

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Engine starting

leave it Never start the engine, or leave it running, when the vehicle is in an enclosed space. Exhaust gasses are poisonous and can cause unconsciousness and death if inhaled.

do not If the engine fails to start, do not continue cranking as this will discharge the battery. It may also damage the catalytic convertor due to unburnt fuel passing through the exhaust.

Note: For diesel engined vehicles the delay period before cranking begins will be longer in low ambient temperatures due to extended glow plug operation. During this extended delay the clutch pedal (manual transmissions) or brake pedal (automatic transmissions) must remain depressed.

The diesel engine glow plug

The diesel engine glow plug warning lamp will remain illuminated while the glow plugs are operating.

READ NEXT:

 Engine starting: automatic transmission

1. A valid Smart Key must be inside the vehicle. 2. Make sure the gear selector is in P or N. 3. Firmly depress the brake pedal. 4. Press and release the start button. The engine will crank autom

 Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine. 1. A valid Smart Key must be inside the vehicle. 2. Fully depress the clutch pedal. 3. Press and release the start button. For

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

SEE MORE:

 Cooling System Partial Draining, Filling and Bleeding

Draining CAUTIONS: The engine cooling system must be maintained with the correct concentration and type of anti-freeze solution to prevent corrosion and frost damage. Failure to follow this instruction may result in damage to the engine. Engine coolant will damage the paint finished surfaces. If

 Control Diagram, System Operation

Control Diagram NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect Network (LIN) Bus CONTROL DIAGRAM - SHEET 1 OF 2 Battery Starter motor fuse Battery Junction Box (BJB) Starter motor Generator Transmission Control Module (TCM) Cooling fan control module Air Conditioning

© 2011-2025 Copyright www.rrevoque.org