Range Rover Evoque: Xenon lamps
High voltage is required to
ignite the
gas and metal vapour which are used
to power Xenon lamps. Contact with
this voltage can cause serious injury.
Replacement or maintenance of
Xenon lamps should only be carried
out by suitably qualified personnel.
Xenon lamp units operate at a very
high temperature. Ensure that the
lamp units have cooled before
attempting to touch them.
Xenon lamp units contain Mercury
which is highly toxic and can be
extremely harmful.
Seek advice about the
correct
disposal of Xenon lamp units from a
Land Rover Dealer or your local
authority.
READ NEXT:
Headlamps
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove
Direction indicator and side lamp bulbs
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb hous
Rear lamp bulbs
1. Remove the two fixings.
2. Direction indicator.
3. Reversing lamp
Turn the relevant bulb holder counter
clockwise and pull to remove from the lamp
unit. Grip the holder then press the bulb i
SEE MORE:
How it works
Viewing angles for driver and front seat
passenger are such that neither can view the
full display that the other is viewing. However,
there is an optimum viewing angle of 30
degrees where no cross over of images can be
perceived. From this point, the closer to screen
centre or screen side edg
Replacement sensor
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The vehicle needs to be stationary for
15 minutes during the sensor fitment before
the system is ready
© 2011-2025 Copyright www.rrevoque.org
