Range Rover Evoque: Commandshift™
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Gearbox / Commandshift™
To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.
Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.
READ NEXT:
Kick-down
Push the accelerator pedal fully down to
achieve rapid acceleration in automatic mode.
When the pedal is relaxed, normal gear
changing will resume.
Drive selector
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is sw
Drive selector fails to elevate
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
SEE MORE:
Warning Devices
Warning Devices - Component Location
Component Location - Blind Spot Monitoring System
Battery
Voltage quality module
CJB (central junction box)
RH (right-hand) door mirror
RH blind spot monitoring module
RJB (rear junction box)
LH (left-hand) blind spot monitoring module
LH door mirror
B
Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm
2. Torque: 6 Nm
3. Torque: 6 Nm
4.
5.
6.
7. NOTE: Do not disassemble further if the
component is removed for access only.
8. Torque: 0.6 Nm
9.
10. Torque: 1 Nm
11.
Installation
1. To install,
© 2011-2025 Copyright www.rrevoque.org
