Range Rover Evoque: Handles, Locks, Latches and Entry Systems
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Handles, Locks, Latches and Entry Systems
- Locks, Latches and Entry Systems
- Handles, Locks, Latches and Entry Systems - System Operation and Component Description
- Front/Rear Door Latch
- Exterior Front/Rear Door Handle
READ NEXT:
Locks, Latches and Entry Systems
Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; F = RF transmission; N = Medium speed CAN (controller
area network) bus; O = LIN (local
interconnect network) bus.
Instrument cluster
CJB (central junction bo
SEE MORE:
Suspension Top Mount
Removal
NOTES:
The suspension top mount is manufactured from mild steel and RP220.
The service panel is serviced not fully spot welded.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2.
Roof Panel Vehicles Without: Sliding
Roof Opening Panel
Removal
NOTES:
The roof panel is manufactured from aluminium 6111T4.
The screw in studs must be renewed with the installation of a new roof panel.
1. The roof panel is replaced in conjunction with:
Liftgate
Windshield
Headliner
2. For additional information relating to this repair procedure p
© 2011-2025 Copyright www.rrevoque.org
