Range Rover Evoque: Seat belt safety

contamination of the webbing with Care should be taken to avoid contamination of the webbing with polishes, oils and chemicals, and particularly battery acid. Cleaning may safely be carried out using mild soap and water.
The belt should be replaced if webbing becomes frayed, contaminated or damaged.
It is essential to replace the entire assembly after it has been worn in a severe impact even if damage to the assembly is not obvious.
If any damage, wear, cuts, defects, or impaired operation are noted with the seat belts, the vehicle should be taken to a Land Rover Dealer/Authorised Repairer for immediate attention. Do not use the vehicle if the seat belts cannot be operated correctly.
Do not carry hard, fragile, or sharp items between your person and the seat belt.
Seat belts should be worn by all vehicle occupants, for every journey no matter how short.
Never wear just the lap belt or just the shoulder belt of a lap/shoulder diagonal seat belt. Both of these actions are extremely dangerous and may increase your risk of injury.
When using seat belts to restrain items other than occupants, take care to ensure that the belts are not damaged, or exposed to sharp edges.

READ NEXT:

 Seat belt checks

Note: If the vehicle is parked on an incline, the seat belt mechanism may lock. This is not a fault and the belt should be gently eased out from the upper anchorage. The seat belts should be inspe

 Seat belt reminder

Seat belt reminder If a front seat belt is not fastened when the vehicle is in motion, a chime will be heard and the seat belt warning lamp will illuminate. Note: Objects on the front passenger

 Beltminder

A front and rear seat Beltminder system warns the driver when the seat belt of an occupied seat is not fastened or is unfastened during a journey. Beltminder A graphic accompanied by a text mes

SEE MORE:

 Transmission Vehicles With: M66 6-Speed Manual Transmission FWD - Removal

Removal Special Tool(s) 205-857 Remover, Halfshaft 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine General Equipment Transmission jack 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refe

 Fuel Tank

Special Tool(s) 310-123 Locking Ring, Fuel Tank Removal WARNINGS: Fuel may still be present in the fuel tank after draining. Avoid flames, sparks or lighted substances. CAUTIONS: Extreme cleanliness must be exercised when handling these components. Make sure that all openings are sealed. Use new

© 2011-2025 Copyright www.rrevoque.org