Range Rover Evoque: Reprogramming a single garage door opener button
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener / Reprogramming a single garage door opener button
To programme a device to a previously programmed button: 1. Press and hold the desired pre-programmed HomeLink button for at least 20 seconds, but no longer than 30 seconds, until the indicator lamp begins to flash.
2. Without releasing the button, position the hand-held transmitter approximately 50 to 150 mm (2 to 6 inches) away from the HomeLink transceiver, keeping the indicator lamp in view.
3. Carry out Step 3 of Programming.
READ NEXT:
To erase all programming
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep th
Entry gate programming
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
HomeLin
Information and assistance
It is recommended that when
you sell or
dispose of the vehicle, the programmed
HomeLink buttons be erased for
security purposes.
For information on the range of available
compatible products or
SEE MORE:
Rear Quarter Window Glass 5-Door
Removal
1. Refer to: Rear Quarter Panel Moulding (501-08 Exterior Trim and
Ornamentation, Removal and Installation).
2. Refer to: C-Pillar Upper Trim Panel (501-05 Interior Trim and
Ornamentation, Removal and Installation).
3. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and
Ornamentation, Re
Spring Vehicles Without: Dynamic Suspension
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's instructions.
The spring is under extreme tension, care must be taken at all times. Failure to
foll
© 2011-2025 Copyright www.rrevoque.org
