Range Rover Evoque: Eco stall recovery

In the event that the engine stalls, it can be restarted by fully depressing the clutch pedal.

Note: Automatic stall restart will only operate once. If the engine is stalled a second time the engine must be restarted normally.

READ NEXT:

 Emission control system

Land Rover vehicles are fitted with emission and evaporative control systems. In many countries it is unlawful to tamper, modify or replace such equipment and legal penalties apply if the laws are

 Diesel particulate filter (DPF)

Diesel vehicles equipped with a particulate filter have more efficient emission control. The particles in the exhaust gases are collected in the filter during normal driving. When a DPF message is

 Gearbox

SEE MORE:

 Wheel Knuckle Rear Bushing

Special Tool(s) 204-620-01 Installer, Wheel Knuckle Bushing 204-620-02 Remover/Installer, Wheel Knuckle Bushing 204-620-03 Remover, Wheel Knuckle Bushing LR-121 Hydraulic Cylinder 10t Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Remove the

 Multifunction Electronic Modules

Torque Specifications Front Door Module (FDM) Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refer to: Front Door Trim Panel (501-05 Interior

© 2011-2024 Copyright www.rrevoque.org