Range Rover Evoque: Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console.

If the engine is switched off with N selected, the system will wait for 10 minutes before selecting P. This time delay allows the vehicle enough time to be conveyed through a car wash. Do not use for vehicle recovery purposes.

If your vehicles requires recovery by towing, the recovery must be undertaken by qualified personnel. See 216, RECOVERY.

READ NEXT:

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

 Transmission fault

In the event that the transmission develops a fault, a warning message may be displayed in the message centre and only limited gears may become available. You should seek qualified assistance imme

 Manual transmission

Manual transmission Selection of reverse gear is prevented when the vehicle is travelling in excess of 24km/h (15mph). Never attempt to engage reverse gear while the vehicle is in forward mo

SEE MORE:

 Instrument Cluster (IC)

 CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.  NOTES: If the control module or a component

 Power Brake Actuation

Brake Booster - Component Location COMPONENT LOCATION - 2.2L Td4 NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar Brake booster Vacuum pipe (vehicles with stop/start system) Vacuum pump Vacuum pipe (vehicles without stop/start system) Non return val

© 2011-2025 Copyright www.rrevoque.org