The rotary drive selector rotates in either
direction. At engine start up, the selector
elevates out of its parked position.
1. To select D (Drive) or R (Reverse) gear,
apply the foot brake then
Use when the vehicle is parked. The
transmission will be locked.
Park (P) or Neutral (N)
should be
engaged and the parking brake
applied when the vehicle is
stationary.
Always select P and sw
Never select Reverse (R) when
the
vehicle is in forward motion.
Before selecting reverse gear, ensure the
vehicle is stationary and the brakes are applied.
Rotate to R.
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
Removal
NOTES:
The A-pillar outer panel is manufactured from mild steel. The fender
mounting bracket is serviced on the new panel.
The upper and lower butt joint must be MIG brazed due to the location of a boron
reinforcement.
A new anti tamper VIN indentification decal will be required when rep