Range Rover Evoque: Rear Quarter Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).
2. Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
3.
4.
5.
6. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
7.
8. NOTE: Do not disassemble further if the component is removed for access only.
9.
Installation
1. CAUTIONS:
Make sure that a new bolt is installed.
Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
B-Pillar Upper Trim Panel 3-Door
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. CAUTION: Discard the bolt.
NOTE: 5-door illustration shown, 3-door is similar.
Torque: 45 Nm
4.
5. Torque: 6 Nm
6.
7. NOTE: 5-door illustration shown, 3-door is similar.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly installed.
NOTE: Make sure the safety belt is operating correctly.
To install, reverse the removal procedure.
Interior Trim and Ornamentation
Torque Specifications
READ NEXT:
Exterior Trim and Ornamentation
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre
Rear View Mirrors
Rear View Mirrors - Component Location
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar.
DDM (driver door module)
Driver exterior mirror
Exterior mirro
SEE MORE:
Deselecting valet mode
If Valet mode is active when you enter the
vehicle, touch the Valet button to view the
Valet mode screen.
Enter your four digit PIN and touch the OK
button.
Valet mode is deactivated is displayed.
- The tailgate will return to the previously set
security requirement.
- All touch screen funct
Gradient release control (GRC)
With HDC activated, if the vehicle is stopped on
a slope using the foot brake, GRC will become
active (except in Terrain Response Sand
program). It operates in all gears and in neutral
position.
During a steep hill descent, when the foot brake
is released GRC will automatically hold brake
for
