Range Rover Evoque: Suspending and resuming cruise control

Suspend cruise control with a single press of control (3).

To resume cruise control at the previous set speed, press control (2).

if the RES (2) should be used only if the driver is aware of the set speed and intends to return to it.
It is not recommended to resume set speed when a low gear is selected as excessive engine speeds will occur.

READ NEXT:

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

SEE MORE:

 Using the touch screen

Always run the engine during prolonged use of the touch screen. Failure to do so may discharge the vehicle battery, preventing the engine from starting. Avoid spilling or splashing liquids onto the touch screen. Switching on - Switch on the ignition. - Switch on the touch screen. The mos

 Headlamp washers

The optional headlamp power wash operates automatically with the windscreen wash and will operate only If the headlamps are switched on and there is sufficient washer fluid in the reservoir. Headlamp wash operates every fourth operation of the screen washers, provided the headlamps are still

© 2011-2025 Copyright www.rrevoque.org