Range Rover Evoque: Engine starting: automatic transmission

1. A valid Smart Key must be inside the vehicle.

2. Make sure the gear selector is in P or N.

3. Firmly depress the brake pedal.

4. Press and release the start button. The engine will crank automatically until it starts. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.

READ NEXT:

 Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine. 1. A valid Smart Key must be inside the vehicle. 2. Fully depress the clutch pedal. 3. Press and release the start button. For

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

 Switching off the engine

Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied. 1. Select P for automatic transmission, or neutral for manual transmissions. Note: If any ot

SEE MORE:

 Brake systems (red)

Brake systems (red) Illuminates briefly when the ignition is switched on. If the lamp illuminates while driving, suspect low brake fluid level or a fault with the Electronic Brake Distribution (EBD) system. Stop the vehicle as soon as safety permits. If the message CHECK BRAKE FLUID is dis

 Brake System - General Information

Brake System Bleeding CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water. NOTES: Bleeding of the complete brake system must be carried out using Land Rover approved diagnostic equipment. Where only the primary or seconda

© 2011-2025 Copyright www.rrevoque.org