Range Rover Evoque: If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult your Dealer/Authorised Repairer.
Diesel engines:
If the engine persistently fails to start, make
sure the transmission is in P or N (neutral for
manual transmission vehicles) then press the
START/STOP button (with the brake pedal
applied). Keep the START/STOP button and the
brake pedal pressed until the engine starts,
then release.
If the engine still fails to crank, or fails to start
consult your Dealer/Authorised Repairer.
READ NEXT:
Before switching off the engine, ensure that the
vehicle is parked safely with the park brake
applied.
1. Select P for automatic transmission, or
neutral for manual transmissions.
Note: If any ot
It is not advisable to switch
off the
engine while the vehicle is moving.
However, should such a situation
arise, then the following procedure
applies.
- Press and hold the engine START/STOP
If the engine is switched off while the vehicle is
moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and
then press the engine START/STOP button.
When the en
SEE MORE:
Special Tool(s)
100-012
Slide Hammer
307-594
Installer, Seal
308-005
Remover, Axle oil seal
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. WARNING: To avoid accidental deployment, the restraints
control module backup power
© 2011-2025 Copyright www.rrevoque.org
