Range Rover Evoque: Rolling re-start

If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.

Automatic transmission - select neutral (N) and then press the engine START/STOP button.

When the engine re-starts, select transmission position D.

Manual transmission - depress the clutch and then press the engine START/STOP button.

When the engine re-starts, select an appropriate forward gear.

READ NEXT:

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start t

 Stop/start (manual transmission only)

The Stop/Start system has been designed to improve fuel efficiency. The system is automatically activated when the ignition is switched on. When the engine has been stopped by the stop/start syst

 Conditions preventing automatic engine stop

The engine will not automatically stop if:<> - the external temperature is below approximately 0°C (32°F) - the external temperature is above approximately40°C (104°F) - engine has not re

SEE MORE:

  Transfer Case Seal RH TD4 2.2L Diesel

Special Tool(s) 100-012 Slide Hammer 205-872 Installer, Transfer Case Seal 308-615 Remover, Seals 308-617 Depth Drill, Seal Remover Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is alway

  Exhaust System

Exhaust System - GTDi 2.0L Petrol Lubricants, Fluids, Sealers and Adhesives * Apply to area around sensor threads prior to attempting to remove sensor General Specification Torque Specifications ** It is not appropriate to either fit or remove these fixings using air tools due to a risk of cold

© 2011-2026 Copyright www.rrevoque.org - 0.0231