Range Rover Evoque: Daytime running lamps
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Exterior lights / Daytime running lamps
Daytime running lamps are LED lamps.
With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch on automatically under the following conditions: - The engine is running.
- The gear selector is out of park (automatic transmission).
- The parking brake is not applied - market dependent.
Unless required or prohibited by law, daytime running lamps can be disabled or enabled by your Dealer/Authorised Repairer.
READ NEXT:
Headlamp courtesy delay
This feature operates whenever the lamps
master switch is in the AUTO (5) position and
the ignition is turned off. The headlamps will
remain illuminated for up to 240 seconds.
Note: The time delay
High beam assist
This feature of the Xenon lighting automatically
selects and deselects high beam, under
specific conditions of road lighting and in the
absence of other vehicle’s lights. The system is
only acti
Auto lamps windscreen wiper detection
If Auto lamps is selected and the windscreen
wipers are switched on for 20 seconds or
more, the side lamps, tail lamps and
headlamps will switch on automatically. When
the wipers are switched off,
SEE MORE:
A-Pillar Reinforcement
Removal
NOTES:
The A- Pillar reinforcement is manufactured from DP600, it is serviced
with its upper and lower door hinge mounting
brackets.
The A-Pillar reinforcement is unpicked from the side panel reinforcement
'ring-frame', it is not serviced separately.
If the A-pillar reinforcement is dama
Body Repairs - Corrosion Protection
Corrosion Protection
Galvanic Corrosion
Galvanic corrosion is the cross-contamination of dissimilar metals, in this
case aluminium and steel. Avoidance of galvanic
corrosion is an important issue to be considered in the repair of aluminium
bodied vehicles.
Precautions to prevent the contamination
© 2011-2026 Copyright www.rrevoque.org
