Range Rover Evoque: Engine starting: manual transmission

Note: Do not press the accelerator pedal when starting the engine.

1. A valid Smart Key must be inside the vehicle.

2. Fully depress the clutch pedal.

3. Press and release the start button. For diesel engined vehicles there may be a delay while the glow plugs warm up, then the engine will crank automatically until it starts.

READ NEXT:

 If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance. If the engine fails to crank, or fails to start, consult

 Switching off the engine

Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied. 1. Select P for automatic transmission, or neutral for manual transmissions. Note: If any ot

 Switching off the engine with the vehicle moving

It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP

SEE MORE:

 Opening and closing the bonnet

Opening and closing the bonnet Opening 1. Pull the bonnet release lever, located in the left-hand front footwell. 2. Lift the bonnet safety catch lever, located below the centre point of the bonnet, then raise the bonnet. Closing Do not drive with the bonnet retained by the safety catc

 Transmission GTDi 2.0L Petrol - Removal

Special Tool(s) 205-857 Remover, Halfshaft 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine JLR-303-1591 Lifting Bracket, Engine - Rear General Equipment Transmission jack NOTE: Some variation in the illustrations may occur, but the essential information is alway

© 2011-2026 Copyright www.rrevoque.org