Range Rover Evoque: Cruise eco data

Diesel only

When enabled, a CO2 emission indicator is

When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEHICLE INFORMATION AND SETTINGS MENU.

READ NEXT:

 Stability control

 Dynamic stability control (DSC)

DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs. The vehicle is not designed for cornering at the sa

 Dsc warning lamp

The amber DSC warning lamp in the instrument panel illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp flashes while driving, the DSC

SEE MORE:

 Inner Constant Velocity (CV) Joint Boot

Special Tool(s) 303-D121 Puller, General Purpose General Equipment Vise Removal NOTE: RH inner constant velocity joint boot shown, LH is similar. 1. Refer to: Rear Halfshaft LH (205-05 Rear Drive Halfshafts, Removal and Installation). Refer to: Rear Halfshaft RH (205-05 Rear Drive Halfshafts, Re

 Evaporator Temperature Sensor

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installa

© 2011-2026 Copyright www.rrevoque.org